diff options
author | Joel Challis <[email protected]> | 2024-09-02 03:48:17 +0100 |
---|---|---|
committer | GitHub <[email protected]> | 2024-09-02 03:48:17 +0100 |
commit | 3bd303f204a59ed950934f5da4c299a8be33b363 (patch) | |
tree | 17ff660931b925909be4a75fba55bd67441bf2bb /docs | |
parent | 096aca63c5d7789669d90ef5f128189be85b7a35 (diff) | |
download | qmk_firmware-3bd303f204a59ed950934f5da4c299a8be33b363.tar.gz qmk_firmware-3bd303f204a59ed950934f5da4c299a8be33b363.zip |
Remove `arm_atsam` platform (#24337)
Diffstat (limited to 'docs')
-rw-r--r-- | docs/compatible_microcontrollers.md | 4 | ||||
-rw-r--r-- | docs/drivers/gpio.md | 2 |
2 files changed, 1 insertions, 5 deletions
diff --git a/docs/compatible_microcontrollers.md b/docs/compatible_microcontrollers.md index 785aee30d5..e2d27e06f2 100644 --- a/docs/compatible_microcontrollers.md +++ b/docs/compatible_microcontrollers.md @@ -75,10 +75,6 @@ You can also use any ARM chip with USB that [ChibiOS](https://www.chibios.org) s For a detailed overview about the RP2040 support by QMK see the [dedicated RP2040 page](platformdev_rp2040). -## Atmel ATSAM - -There is limited support for one of Atmel's ATSAM microcontrollers, that being the [ATSAMD51J18A](https://www.microchip.com/wwwproducts/en/ATSAMD51J18A) used by the [Massdrop keyboards](https://github.com/qmk/qmk_firmware/tree/master/keyboards/massdrop). However, it is not recommended to design a board with this microcontroller as the support is quite specialized to Massdrop hardware. - ## RISC-V ### GigaDevice diff --git a/docs/drivers/gpio.md b/docs/drivers/gpio.md index 9ce4f2aa20..b21a17bc39 100644 --- a/docs/drivers/gpio.md +++ b/docs/drivers/gpio.md @@ -13,7 +13,7 @@ The following macros provide basic control of GPIOs and are found in `platforms/ |`gpio_set_pin_input_low(pin)` |Set pin as input with builtin pull-down resistor (unavailable on AVR)| |`gpio_set_pin_output(pin)` |Set pin as output (alias of `gpio_set_pin_output_push_pull`) | |`gpio_set_pin_output_push_pull(pin)` |Set pin as output, push/pull mode | -|`gpio_set_pin_output_open_drain(pin)`|Set pin as output, open-drain mode (unavailable on AVR and ATSAM) | +|`gpio_set_pin_output_open_drain(pin)`|Set pin as output, open-drain mode (unavailable on AVR) | |`gpio_write_pin_high(pin)` |Set pin level as high, assuming it is an output | |`gpio_write_pin_low(pin)` |Set pin level as low, assuming it is an output | |`gpio_write_pin(pin, level)` |Set pin level, assuming it is an output | |