diff options
Diffstat (limited to 'Projects/XPLAINBridge/XPLAINBridge.txt')
-rw-r--r-- | Projects/XPLAINBridge/XPLAINBridge.txt | 15 |
1 files changed, 10 insertions, 5 deletions
diff --git a/Projects/XPLAINBridge/XPLAINBridge.txt b/Projects/XPLAINBridge/XPLAINBridge.txt index f22feca8e3..3f4647e61b 100644 --- a/Projects/XPLAINBridge/XPLAINBridge.txt +++ b/Projects/XPLAINBridge/XPLAINBridge.txt @@ -54,12 +54,17 @@ * will enumerate as a regular COM port on the host, which can then be opened and data exchanged between the XMEGA and Host as if * the XMEGA was connected directly to the host's serial port. If the pin is pulled low by shorting it to GND (pin 10), the device * will enumerate as an AVRISP-MKII to the host, so that the XMEGA can be reprogrammed by AVRStudio or other compatible software - * such as avrdude. + * such as avrdude by connecting to the board as if it was an Atmel AVRISP-MKII programmer. * - * After running this project for the first time on a new computer, you will need to supply the .INF file located in this project - * project's directory as the device's driver when running under Windows. This will enable Windows to use its inbuilt CDC drivers, - * negating the need for custom drivers for the device. Other Operating Systems should automatically use their own inbuilt CDC-ACM - * drivers. + * After running this project in serial bridge mode for the first time on a new computer, you will need to supply the .INF file + * located in this project project's directory as the device's driver when running under Windows. This will enable Windows to use + * its inbuilt CDC virtual serial drivers, negating the need for custom drivers for the device. Other Operating Systems should + * automatically use their own inbuilt CDC-ACM drivers. + * + * In serial bridge mode, the UART baud rate can be altered through the host terminal software to select a new baud rate - the default + * baud is 9600. Note that parity, data bits and stop bits are fixed at none, eight and one respectively can cannot be altered. Changes + * to the connection's parity, data bits or stop bits are ignored by the firmware. As the serial link between the controllers on the + * XPLAIN is software emulated by the USB AVR, not all baud rates will work correctly. * * This project relies on files from the LUFA AVRISP-MKII project for compilation. * |