diff options
Diffstat (limited to 'docs')
| -rw-r--r-- | docs/feature_split_keyboard.md | 10 | ||||
| -rw-r--r-- | docs/ja/proton_c_conversion.md | 1 | ||||
| -rw-r--r-- | docs/proton_c_conversion.md | 1 | ||||
| -rw-r--r-- | docs/serial_driver.md | 1 | 
4 files changed, 13 insertions, 0 deletions
| diff --git a/docs/feature_split_keyboard.md b/docs/feature_split_keyboard.md index b234114200..c285e353d4 100644 --- a/docs/feature_split_keyboard.md +++ b/docs/feature_split_keyboard.md @@ -181,6 +181,16 @@ If you're having issues with serial communication, you can change this value, as  * **`4`**: about 26kbps  * **`5`**: about 20kbps +```c +#define SPLIT_MODS_ENABLE +``` + +This enables transmitting modifier state (normal, weak and oneshot) to the non +primary side of the split keyboard.  This adds a few bytes of data to the split +communication protocol and may impact the matrix scan speed when enabled. +The purpose of this feature is to support cosmetic use of modifer state (e.g. +displaying status on an OLED screen). +  ###  Hardware Configuration Options  There are some settings that you may need to configure, based on how the hardware is set up.  diff --git a/docs/ja/proton_c_conversion.md b/docs/ja/proton_c_conversion.md index 6e4f7dcb66..e7c07413ce 100644 --- a/docs/ja/proton_c_conversion.md +++ b/docs/ja/proton_c_conversion.md @@ -51,6 +51,7 @@ Proton C には1つのオンボード LED(C13)しかなく、デフォルトで�  ```  MCU = STM32F303 +BOARD = QMK_PROTON_C  ```  次の変数が存在する場合は削除します。 diff --git a/docs/proton_c_conversion.md b/docs/proton_c_conversion.md index 1b5e496e74..47511e1b1e 100644 --- a/docs/proton_c_conversion.md +++ b/docs/proton_c_conversion.md @@ -44,6 +44,7 @@ To use the Proton C natively, without having to specify `CTPC=yes`, you need to  ```  MCU = STM32F303 +BOARD = QMK_PROTON_C  ```  Remove these variables if they exist: diff --git a/docs/serial_driver.md b/docs/serial_driver.md index bc376b6ddd..c98f4c1176 100644 --- a/docs/serial_driver.md +++ b/docs/serial_driver.md @@ -60,6 +60,7 @@ Configure the hardware via your config.h:                                     //  5: about 19200 baud  #define SERIAL_USART_DRIVER SD1 // USART driver of TX pin. default: SD1  #define SERIAL_USART_TX_PAL_MODE 7 // Pin "alternate function", see the respective datasheet for the appropriate values for your MCU. default: 7 +#define SERIAL_USART_TIMEOUT 100 // USART driver timeout. default 100  ```  You must also enable the ChibiOS `SERIAL` feature: | 
