aboutsummaryrefslogtreecommitdiff
path: root/keyboards/splitkb/kyria/rev2/config.h
diff options
context:
space:
mode:
Diffstat (limited to 'keyboards/splitkb/kyria/rev2/config.h')
-rw-r--r--keyboards/splitkb/kyria/rev2/config.h31
1 files changed, 2 insertions, 29 deletions
diff --git a/keyboards/splitkb/kyria/rev2/config.h b/keyboards/splitkb/kyria/rev2/config.h
index 54d8f0985a..fb9e7bb959 100644
--- a/keyboards/splitkb/kyria/rev2/config.h
+++ b/keyboards/splitkb/kyria/rev2/config.h
@@ -19,34 +19,7 @@ along with this program. If not, see <http://www.gnu.org/licenses/>.
// Side detection
// col 4 row 3 on right-hand-side
-#define SPLIT_HAND_MATRIX_GRID E6, B3 // row first because the board is col2row
#define MATRIX_MASKED // actual mask is defined by `matrix_mask` in `rev2.c`
-/*
- * Split Keyboard specific options, make sure you have 'SPLIT_KEYBOARD = yes' in your rules.mk, and define SOFT_SERIAL_PIN.
- */
-
-#if defined(CONVERT_TO_PROTON_C)
-# define SERIAL_USART_FULL_DUPLEX // Enable full duplex operation mode.
-# define SERIAL_USART_PIN_SWAP // Swap TX and RX pins if keyboard is master halve.
-# define SERIAL_USART_DRIVER SD1 // USART driver of TX pin. default: SD1
-# define SERIAL_USART_TX_PAL_MODE 7 // Pin "alternate function", see the respective datasheet for the appropriate values for your MCU. default: 7
-# define SERIAL_USART_TX_PIN D3
-# define SERIAL_USART_RX_PIN D2
-
-# define WS2812_DI_PIN PAL_LINE(GPIOA, 3)
-# define WS2812_PWM_DRIVER PWMD2 // default: PWMD2
-# define WS2812_PWM_CHANNEL 4 // default: 2
-# define WS2812_PWM_PAL_MODE 1 // Pin "alternate function", see the respective datasheet for the appropriate values for your MCU. default: 2
-# define WS2812_PWM_DMA_STREAM STM32_DMA1_STREAM2 // DMA Stream for TIMx_UP, see the respective reference manual for the appropriate values for your MCU.
-# define WS2812_PWM_DMA_CHANNEL 2 // DMA Channel for TIMx_UP, see the respective reference manual for the appropriate values for your MCU.
-# define WS2812_PWM_DMAMUX_ID STM32_DMAMUX1_TIM2_UP // DMAMUX configuration for TIMx_UP -- only required if your MCU has a DMAMUX peripheral, see the respective reference manual for the appropriate values for your MCU.
-#else
-# define WS2812_DI_PIN D3
-# define SOFT_SERIAL_PIN D2
-#endif
-
-#ifdef OLED_ENABLE
-# define OLED_DISPLAY_128X64
-# define SPLIT_OLED_ENABLE
-#endif
+#define OLED_DISPLAY_128X64
+#define SPLIT_OLED_ENABLE