1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
|
// Copyright 2024 splitkb.com ([email protected])
// SPDX-License-Identifier: GPL-2.0-or-later
#include "matrix.h"
#include "spi_master.h"
// The matrix is hooked up to a chain of 74xx165 shift registers.
// Pin F0 acts as Chip Select (active-low)
// The signal goes to a NOT gate, whose output is wired to
// a) the latch pin of the shift registers
// b) the "enable" pin of a tri-state buffer,
// attached between the shift registers and MISO
// F0 has an external pull-up.
// SCK works as usual.
//
// Note that the matrix contains a variety of data.
// In addition to the keys, it also reads the rotary encoders
// and whether the board is the left/right half.
void matrix_init_custom(void) {
// Note: `spi_init` has already been called
// in `keyboard_pre_init_kb()`, so nothing to do here
}
bool matrix_scan_custom(matrix_row_t current_matrix[]) {
// Enough to hold the shift registers
uint16_t length = 5;
uint8_t data[length];
// Matrix SPI config
// 1) Pin
// 2) Mode: Register shifts on rising clock, and clock idles low
// pol = 0 & pha = 0 => mode 0
// 3) LSB first: Register outputs H first, and we want H as MSB,
// as this result in a neat A-H order in the layout macro.
// 4) Divisor: 2 is the fastest possible, at Fclk / 2.
// range is 2-128
spi_start(GP13, false, 0, 128);
spi_receive(data, length);
spi_stop();
bool matrix_has_changed = false;
for (uint8_t i = 0; i < length; i++) {
// Bitwise NOT because we use pull-ups,
// and switches short the pin to ground,
// but the matrix uses 1 to indicate a pressed switch
uint8_t word = ~data[i];
matrix_has_changed |= current_matrix[i] ^ word;
current_matrix[i] = word;
}
#ifdef MYRIAD_ENABLE
bool myriad_hook_matrix(matrix_row_t current_matrix[]);
return matrix_has_changed || myriad_hook_matrix(current_matrix);
#else
return matrix_has_changed;
#endif
}
|